M2000.1D

                                                            M2000.1D              

STABLE TO:                                      1 ohm               

CONTINUOUS (RMS) POWER

@ 13.8 Volts:

Watts @ .05 ohms mono                 N/A                    

Watts @ 1 ohms mono                     1 X 2000     

Watts @ 2 ohms mono                     1 X 1100         

Idle Current:                                       1.5 amp 

Signal to Noise Ratio A-Wtd:          <85dB 

Total Harmonic Distortion:              0.3%   

Channel Separation:                          N/A      

Input Sensitivity:                               150mV-2.5V   

Slew Rate:                                           13V / Usec 

Fuse Rating:                                        100 amp    

Dimensions:

Height:                       2.25” 
Width:                         9.5” 

Length:               10” 

General Information:

Frequency Response:                <10Hz to 275Hz

Low-pass Filter:                        Variable 24db, 77 to 275Hz

Battery Connectors:                   2 Gauge

Speaker Connectors:                 8 Gauge

CONTROLS AND CONNECTORS

(1) Positive Power Terminals –This is the power feed from the positive (+) terminal of the car’s battery. Use 4-gauge cable (MINIMUM) and good quality terminals when routing this connection. Tighten all connections well to prevent power loss due to bad contact. Route the power cable away from the RCA jacks and speaker cables

(1) Ground Terminals - For optimum performance, use 4-gauge cable MINIMUM! Connect this cable to your battery’s negative (-) terminal or to a secure area of the body in the trunk. *See note below.

Remote Terminal - The amplifier will turn on when 12 volts is applied to this terminal. This 12-volt signal is usually taken from the Power Antenna or Remote wire coming from the source unit.

Speaker Terminals - Connect to speakers using 16-gauge wire (minimum). Running too low of a speaker impedance will cause the amplifier to go into a fault condition.

Crossover Filter – Linkwitz/Riley 24db slope. This control sets the 6db down point of your amplifier.

Gain – Allows input levels between 150mV (max gain) and 2.5 volts (min gain) for full output.

Recommended Fuse – 80 amperes.

Recommended Battery: You should use 1 battery for each pair of amplifiers. If your system uses only 1 amplifier, then the starter battery is sufficient.  Note:  When you have to parallel 2 or more batteries together always use the same, size, brand and amperage of battery. This will ensure that the batteries charge equally. We do not recommend battery isolators. At 2 or more batteries, you will need to upgrade your alternator. The starter battery should always be upgraded with a high output audio battery.

Note: If you use the chassis as a source for your ground in the trunk, you MUST increase the size of the wire that runs from the front battery to the fender. Remember; 12 volts has to run in a continuous loop and if you do not increase the ground wire up front the voltage/current will be restricted and your system will not play to its fullest.